SOHC.co.uk Forums > CB500/550
Tapered head bearings question
sye:
Do you still use the lower dust seal and washer when fitting tapered head bearings? Just checking before I fit them and there's none in the kit and no destructions either. Thanks, Sye.
Trigger:
If it is a Allballs, you fit the medium washer then the seal and then the bearing ;)
sye:
QMP from DSS Graham? Two bearings and one washer is all there is...
Rob62:
Yep.... no seal in that kit. The instructions mention a seal but only for the 400cc model iirc. Bit of a poor job in my opinion but hey ho. Put plenty of grease on it and dont go out in the rain and it should be ok :-\
sye:
I can easily return it and order a different make?
Navigation
[0] Message Index
[#] Next page
Go to full version