SOHC.co.uk Forums > The Black Bomber Board

Bomber fork leg

(1/3) > >>

royhall:
Just stripped the forks for the Bomber after finally getting the seal holders off. This is what I found underneath, got to be the worst corrosion I have ever seen on a fork leg. It measures about 12 thou deep so is probably way outside rechroming limits. Don't suppose anyone has a spare fork tube for a Black Bomber CB450K0 going spare. Once again it appears to be a big ask.


[ Guests cannot view attachments ]


[ Guests cannot view attachments ]

AshimotoK0:
Probably got one Roy but it will need rechroming.... no way as bad at that one though .. Will look tomorrow for you

royhall:
Ash to the rescue yet again. They are going off to philpotts anyway but that ones going in the scrap. I think this build would be impossible if it wasn't for your stash. Cheers Ash.

AshimotoK0:
Here ya'go Roy. Should rechrome fine.
I will get it off to you ASAP.

I just noticed on these that the Bomber stanchion waists slightly above the Bottom yoke. Did you notice that on yours?

Cheers "Ash-From-The-Stash"  ;D ;D


[ Guests cannot view attachments ]

royhall:
Thanks Ash looks better than the one I have. Yes they do angle in above the yoke. Not sure Philpotts are going to like these as there are different diameters, angles, and several circlip grooves to be ground back in. Might be pricey. I will drop some cash into your Paypal account for postage of the growing list of parts. Thanks again.

Navigation

[0] Message Index

[#] Next page