Author Topic: Welding centre stand brackets back on in the right place  (Read 931 times)

Offline Corascate

  • Newbie
  • Posts: 35
  • If you can’t make me skinny, make my friends fat
    • View Profile
Welding centre stand brackets back on in the right place
« on: April 19, 2020, 04:14:17 PM »
Hi all
When I put my K7 on its centre stand both wheels are on the deck (solidly) when I took measurements it was wrong by 17mm, previous owner had done some “work” and welded them on the the frame in the wrong place, so I have cut them off (pig of a job due to lack of space)
I have now got them off, and my plan is to assemble the centre stand pivots complete and the offer it up to the frame , then when I have it in the correct position, tack it into place with a couple of good tacks try it out  and if satisfactory then weld it fully.
Does this sound right to you ,or have you got any better ideas .
I just need to get the bike so that it sits right on its stand
Cheers
Steve

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal