SOHC.co.uk Forums > CB500/550
centre stand refit
MIKE550/4:
had some fun fittting this today
had it put on fine so i thought, then noticed the u shape hangar was cutting into my newly powder coated stand aaarghhh!
anyway have that sorted , centre stand is on and works fine can touch up the scratch
question if you look at pics there is a little black plate with 3 holes in it , have i fitted this correct and can some remind what this does
cheers mike
to steve d bit cleaner dont you think ;)
pics to follow
Bryanj:
According to the parts book that plate should be underneath oh the RH side and is to hold the carb drains etc
MIKE550/4:
cheers bryan will move it down to bottom of bolt,
hmmm one hole is much bigger than the other does it show how many drain tubes goes down each hole
hobbers:
If you are still reading this - thanks for postng the image. I'm restoring a 550F1 and couldn't remember how to fit the spring - even thought I'd power-coated the half-moon bracket - doh!
mickwinf:
Mike I think all the carb drains go through the big hole, the small hole is for the battery overflow if I recall correctly
Navigation
[0] Message Index
[#] Next page
Go to full version