SOHC.co.uk Forums > Anorak's Corner
Tap n die set recommendations
mickwinf:
I have a set from Aldi, works well for occasional use. One thing to watch for is the 10mm size as most sets have a 1.5 thread pitch and hondas use a 1.25 fine pitch. As Laverda Dave said, tracy tools very good for this type of thing
K2-K6:
General recommendation to go with the tools mentioned above
https://www.bearingboys.co.uk/Rocol/Rocol-RTD-Compound-50g-53020-167584-p?gclid=EAIaIQobChMI2aeDvrqp6gIVQ-7tCh2-BwBgEAQYAiABEgL3PvD_BwE
Still the finest thread cutting lubricant known to man ;D ;D ;D
Makes the best thread finish, refined cut and least "oversize" final threads by reducing tool drag during use. Well worthwhile.
philward:
I've had this on watch on ebay for some time - keep bottling out as would only use occasionally
https://www.ebay.co.uk/itm/DRAPER-75-Pce-Metric-Tap-Wrench-Split-Die-Coarse-Fine-Thread-Set-M2-M12-79205/391740316201?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649
Bryanj:
When we get back to "normal" a good idea is to rumage at autojumbles, steam fairs etc so you get a day out and buy quality stuff Presto is a good name
sprinta:
--- Quote from: philward on June 30, 2020, 12:58:15 PM ---I've had this on watch on ebay for some time - keep bottling out as would only use occasionally
https://www.ebay.co.uk/itm/DRAPER-75-Pce-Metric-Tap-Wrench-Split-Die-Coarse-Fine-Thread-Set-M2-M12-79205/391740316201?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649
--- End quote ---
Made from Carbon Steel not High Speed Steel, HSS.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version