David Silver Ignition Coils

[Chainlink]

Hi, only just joined the forum so apologies is this is a repeat question....I did search but couldn’t find anything on this so here goes.....

I have a pair of new coils for my CB550K3 purchased from David Silver a few years back.  They are marked with the cylinder feeds 1-4 and 2-3 but the low tension connectors on both coils have no labels....I would usually expect a + and a -.  My question is which connector connects to which wire on the loom....there is a black and white (common to both coils) and a blue for one coil (cyl 1/4) and a yellow for the other (cyl 2/3).  My assumption, as the connectors on the new coils aren’t marked is that it doesn’t matter.....but would appreciate confirmation or otherwise of that before connecting up.  Thank you.

[JezzaPeach]

Hi I’m sure someone will advise re the coloured wires but I think on my more recent DSS coils for my 500 there was a + and - but just a bit feint to spot. My kit came with some adapter wires that both just needed female bullet connectors putting on one end.

[Chainlink]

Thanks Jeremy.  I have looked very closely and can’t see any marker next to the terminals on the coils.  Like yours I got two small looms to connect the coils to the main bike loom....and mine have the bullets on ready to go..!

Thanks again.....👍