Other Stuff > Tricks & Tips
Fitting rubber bits
mike the bike:
I was trying to fit a motor on a Dyson DC14, I usually have to spray the rubber mounting with WD to get it to go in but a customer was whinging about the oily smell. This time I tried something different.
Alcohol hand cleaning gel.
I used it at home to refit the airbox on my son's Lexmoto. Best stuff I've ever used to fit rubber bits.
Bryanj:
I use silicone spray but if you squeeze too hard you cant find it again
mike the bike:
The hand gel evaporates off once the parts are assembled, which is an advantage over silicon spray.
royhall:
I use a good spray of carb cleaner. Best to get it right first-time as you can't budge them afterwards.
Trigger:
Red Rubber silicone grease, that is what it is for ;)
Navigation
[0] Message Index
[#] Next page
Go to full version