Author Topic: Final drive shaft  (Read 226 times)

Offline Lkp

  • Newbie
  • Posts: 9
    • View Profile
Final drive shaft
« on: March 17, 2021, 06:54:05 PM »
Hi everyone..

I've got a f2 cases and an f1 final drive will this be ok to use?

Online K2-K6

  • SOHC Jedi
  • Posts: 3414
    • View Profile
Re: Final drive shaft
« Reply #1 on: March 17, 2021, 08:17:22 PM »
The F2 (and paired K7) both use a larger final drive bearing to, I think, all the other 750s. This because they use 630 chain size.

I don't think the F1 bearing will fit, can you try and compare the output shaft mounting to give more certainty?

Offline neilg

  • SOHC Associate
  • Posts: 74
    • View Profile
Re: Final drive shaft
« Reply #2 on: March 21, 2021, 06:19:52 PM »
Because of the bigger bearing the engine sprocket is further away from the engine case by about 5mm, so chain alignment needs checking.

Offline hairygit

  • SOHC Jedi
  • Posts: 2660
    • View Profile
Re: Final drive shaft
« Reply #3 on: March 21, 2021, 09:43:43 PM »
The 750F0, F1, F2 and K 7 all use the same bearings on the final drive shaft, but the shafts are different part numbers for the F2 and K7.

Sent from my POT-LX1 using Tapatalk

If it's got tits or wheels, it's hassle, if it's got both, RUN!!!

Offline Bryanj

  • Grogu
  • *
  • Posts: 7807
    • View Profile
Re: Final drive shaft
« Reply #4 on: March 21, 2021, 10:34:33 PM »
F1 andF2 have totally different sprocket retention method

Offline robvangulik

  • SOHC Member
  • Posts: 152
  • Honda Fourever
    • View Profile
Re: Final drive shaft
« Reply #5 on: March 21, 2021, 11:18:13 PM »
+1, F1 has the same method as the earlier K types with 2 m6 bolts in the sprocket, the F2 has the central retaining bolt.

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal