Boot plug for intake manifold

[thomaspigeon]

Haha No problem Bryan, I found it. It’ll take a month to arrive though. Do you know the bandwidth of yours?
I found some 9mm (which is 3mm less than mine), is it narrow enough?
Also I found some cb550 inlet manifold in Germany for £40, worse the shot? I guess I’ll have to change the O-ring straight away. Find the links below. Cheers

https://www.ebay.co.uk/itm/253627467056
https://www.ebay.co.uk/itm/373513175775

[Bryanj]

O rings are same as tappet caps so readily available, if the rubbers are soft enough to use those are wrth a shot i will measure the clips i got seem to remember 8 or 9mm, you will need to cut off lots of extra when you put them on

[mickwinf]

if you have not ordered the maniolds i have a pair of the correct ones, £25 pair plus post

[thomaspigeon]

@oddjob, jubilee clips ordered. A bit expensive but if that does the job I’ll be happy. Thanks for the tip.

[thomaspigeon]

if you have not ordered the maniolds i have a pair of the correct ones, £25 pair plus post

I have PM’d you about it. Thanks

[mickwinf]

hi Tom no message received yet

[thomaspigeon]

I just sent you one now. I’m not really good with that technology