Try our new info resource - "Aladdin's Cave" (Main menu)Just added a separate link to Ash's Dropbox thread (shortcut)
The 500/550 coils though don't snake at all, straight in and straight out. So the smaller hole way of doing them works just great IMO, I have fitted one set of leads in the coil body, I used a 1m length of HT lead and didn't cut it, so it's a large loop at the moment, I put silicon sealant on the end as it slid in so it sealed after fitting. I also intend to slide the outer lead cover right up to both the cap and the coil so in essence the lead is not exposed to the weather at all. The reasoning behind the loop was to ensure I could cut the lead where I wanted so there was no chance of it being too short, as my coils face backward and route across the top of the engine I find having them slightly longer than standard helps to route them completely out of the way. We'll see if the idea pans out I suppose.
The hole is still empty though Ash, so if I filled it mostly will that stuff you sent me wouldn't that not only seal the lead into the body but hold it there as well when it sets?
No I think he's referring to the leads from the coils TO the loom. Not done mine yet but it looks like they'll just unsolder from the coils.