Other Stuff > Member 4 Sales

Honda Throttle grip adjuster ramp 53163-300-020

(1/9) > >>

Oddjob:
This is the small metal ramp that fits inside the bottom half of the right hand switchgear on the CB350, CB360, CB500, CB750 and CL360.

It can also be fitted to both the CB400F, CB550F and CB550K if you want to fit one.

This feature was removed from models after the CB500, it was fitted to enable a fast idle for checking advance/retard unit operation for example. In essence it locks the throttle where you want it, this is very handy on motorways for instance when the pressure of holding the throttle open gets a little wearing. Under the switchgear is a large chrome thumb screw fitted with a chrome spring. When this is screwed in it pushes this small ramp up against the throttle pipe, the more you screw the thumb screw in the stiffer the throttle becomes. So on a motorway you just wind in the screw until the throttle stays open by itself. Most of these ramps get lost when you open the switchgear to change bars or a cable for instance. They tend to drop out and you don't notice, fit these with plenty of grease and they stand a better chance of staying in. If you have a CB400F or a CB550F/K you can still fit one by just drilling and tapping the small boss which is still fitted but never used. You need a 5mm tap. Fit the ramp, the thumb screw and spring and you now have this handy feature.

If you have the thumb screw and spring fitted and winding it in does nothing then the ramp is missing. It's just a small piece of metal bend into a special shape. It is quite expensive for what it is, common price is around $7 but it's the postage that kills buying it from the states, I found quite a few last year and bought the lot so as to split the cost to acceptable levels.

Cost is £7 inc P&P. If you buy with a set of clutch shims or felt washers I'll do them for £5.

I have 10 only. Once they're gone, they're gone as the saying goes.

bruxby-clive:
Hi Ken, can I have one of these as well as the shims requested earlier please, any idea when the shims will be ready?

Oddjob:
Done mate, posted on the thread yesterday they were ready.

bruxby-clive:
Apologies hadn't seen the post until after you replied, £17.00 sent friends and family.

Oddjob:
Have I got your postal address Clive?

Can't remember, if not please PM it.

Payment received BTW. Will send on Tuesday due to Bank Holiday.

Navigation

[0] Message Index

[#] Next page