SOHC.co.uk Forums > SOHC Singles & Twins

CB360 K0 Not well

(1/4) > >>

nairb:
Hello, I have had this cb360 for 3 or 4 years and after its restoration have done some 3.5 k on it without any issues....... except for now.

It starts ok and pulls off ok but now won't rev over 5k in any gear.  Seems fine in the lower revs.  SO, before I start to investigate, I thought I would ask the obvious questions......

1.  Blocked main jet?
2.  Ignition Advance not working.? Stuck.
3.  Points gone duff.  Not looked yet.
4.  Some other mysterious and daft issue.

Ta
Nairb

Bryanj:
3.5 k is dounle the service interval for points and timing PLUS points can, and do hort out on the cover

Johnwebley:
Does it have single coil?


With twin leads?

Have you renewed it?

I had a similar issue with my CB200

turns out the primary resistance was to high,
Needed to be about 3.5 ohm

Revs OK now

Sent from my SM-A546E using Tapatalk

nairb:
Well, I have begun the investigation.  Does a cb360 ever go pop.  Apparently so. 

It's a twin coil/points setup.  All original as far as I know. 

So a quick and simple test is to change the plugs.  And with a new set of sparkies I went for a spin.

It's still unwell.  So those points will be looked at next when it's cooled down.  Maybe a set of points from DS is in order.
Time to check the advance units as well.

Oddjob:
If ordering points, I'd strongly advise buying original, not copies. Copies just don't seem to work as well these days.

Navigation

[0] Message Index

[#] Next page

Go to full version