SOHC.co.uk Forums > Project Board
Project CB350F
magpie114:
Thanks Ian for the information, its a big help. I like your rig setup and will use it as a model. I'm sure I can recover the oil filter housing but thanks for your offer.
Thinking about it you are probably right about the rebore. I've been busy labelling and bagging parts but I made a few quick measurements as a guide. I don't have any means to measure the bores but the pistons and ring gaps are within service limits. I'll measure them accurately when I've cleaned the pistons up properly. I'm not sure how of the best way to remove the surface rust film/glaze tho'.
Johnny4428:
Hi Alan, interesting update on your latest project. I did look at that bike as a potential project, decided to settle for another 550 instead. Nothing horrific revealed which is always good. Keep us posted!
Orcade-Ian:
Hi Alan,
You could try the 'Engine Room' in Motherwell - they ought to be able to accurately measure the bores and if within spec they could probably glaze bust them for you too.
Ian
AshimotoK0:
Nice project to keep you busy over the winter.
If you haven't found them already, these are available in my Dropbox links.
CB350/400F SHOP MANUAL WORKSHOP
https://www.dropbox.com/s/1n3w5433jkph228/350F%20400F%20_4%20Shop%20Manual.pdf?dl=0
CB350F Parts Manual
https://www.dropbox.com/s/7pieydvznvy7nhp/CB350_F_F1%20Full.pdf?dl=0
magpie114:
Good tip Ian thanks. I'll give them a try, they're fairly near too.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version