Try our new info resource - "Aladdin's Cave" (Main menu)Just added a separate link to Ash's Dropbox thread (shortcut)
If it fits, I'd choose the CB500 airfilter element. I has a big filter area and it lasts forever.
Quote from: deltarider on October 30, 2023, 11:22:39 AMIf it fits, I'd choose the CB500 airfilter element. I has a big filter area and it lasts forever.It can easily be made to fit, it just needs a small bracket made to stop it slipping down.
Well thought I would pull the carbs and have a go at improving on the fuel delivery, I think it’s safe to say they are needing a good clean! Number 4 float pin is fighting me a bit, these 50 year old float pin pillars scare me. Wouldn’t take much to break. Think I’ll leave to soak and try tomorrow.
Quote from: McCabe-Thiele (Ted) on October 29, 2023, 07:25:14 PMSomeone needs to invent a pair of broad nosed pliers with a nice slot on one of the jaws to hold against the float pillar on the inside edge - the other jaw needs to have a firing pin so you can push the float hinge pin out.Nice idea Ted! As long as it supports both pillars at the same time. 👍
Someone needs to invent a pair of broad nosed pliers with a nice slot on one of the jaws to hold against the float pillar on the inside edge - the other jaw needs to have a firing pin so you can push the float hinge pin out.
Ooh, that caliper looks horrible! ☹️ Well done for getting the piston out. What's the bore look like?
Quote from: taysidedragon on November 05, 2023, 09:04:26 PMOoh, that caliper looks horrible! ☹️ Well done for getting the piston out. What's the bore look like?Bore was not too bad Gareth and the piston hardly had a mark on it surprisingly. Good clean and a new seal and good to go.