SOHC.co.uk Forums > SOHC Singles & Twins
CD175 Sloper centre stand spring
AshimotoK0:
Unfortunately the 'hook' is a 205 CB92 part which normally equates to inflated £££
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
McCabe-Thiele (Ted):
Whats the arm on the PIvot Shaft for?
paul G:
see it here
Orcade-Ian:
Many thanks Ash and Paul G for the info,
All is not lost it seems, I can easily drill the frame at that point and make a peg with a collar on the outside and a nut and washer on the easily accessible inside. Now I know where it attaches I might even see the head of the original pin on the inside. Ted, the plate on the pivot pin just stops the shaft revolving and rests at the 9 o'clock position.
Ian (A happy old man!)
paul G:
--- Quote from: Orcade-Ian on February 22, 2024, 04:18:13 PM ---Many thanks Ash and Paul G for the info,
All is not lost it seems, I can easily drill the frame at that point and make a peg with a collar on the outside and a nut and washer on the easily accessible inside. Now I know where it attaches I might even see the head of the original pin on the inside. Ted, the plate on the pivot pin just stops the shaft revolving and rests at the 9 o'clock position.
Ian (A happy old man!)
--- End quote ---
The pictures of mine on the end is before it was welded in place.
Ash,
Did you send Ian the drawing you did for me as it was spot on ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version