Try our new info resource - "Aladdin's Cave" (Main menu)Just added a separate link to Ash's Dropbox thread (shortcut)
I bought a crank & con rods from DK for my 500 - they were as described - the con rods shell were like new. 👍👍👍
Quote from: McCabe-Thiele (Ted) on March 01, 2024, 05:43:49 PMI bought a crank & con rods from DK for my 500 - they were as described - the con rods shell were like new. 👍👍👍Whats DK?
If 400four bits has one he is a member on here as as far as i know fully trustworthy.Personaly i would buy crank and rods as chances are the big ends would be ok and you would only need to buy mains.No offence meant but if you are ordering a micrometer to measure the mains you wont be accurate enough, the correct use of mics is an art and the accuracy required is not easy to learn, you would be better taking it to a good engineering firm for accuracy
Both those look same to me and would save you spending roughly £80 on big end shells.Plastigauge is accurat when used correctly but you need a main bearing pin size to start from.What are the letter codes from the rear of your crankcases?