General > Humour
Shockingly Fragile!
Athame57:
--- Quote from: McCabe-Thiele (Ted) on April 15, 2024, 11:53:45 AM ---This is what threw me, mine are working ok so only if they leak or fail will I change them for more genuine looking ones. This seller specifies 317 mm pin/fork as opposed to 315 mm for the more original looking ones.
--- End quote ---
The ones I've just fitted are also 315mm pin/fork but I've had to put some washers in for spacers, there was play. :( Blimey, this started as humour thread? Maybe it should be transferred!
McCabe-Thiele (Ted):
Are you talking about fitting washer at the top mount for alignment or the lower fitting where it clamps to the swing arm?
I had to do some spacing at the top using some washers a member (allankelly1) made for me in SS.
Athame57:
Where it fits to the swing arm.
McCabe-Thiele (Ted):
Does your bottom mount have a threaded plate attached or is it a nut & bolt fitting?
Athame57:
It seems to be threaded without the plate. Whatever, tomorrow it goes into workshop to have a new oil pump seal ( missing from the seal kit I got for the rebuild I had) I'll persuade the mechanic to get me sorted. ;)
Navigation
[0] Message Index
[*] Previous page
Go to full version