SOHC.co.uk Forums > CB350/400

hard neutral

(1/2) > >>

petercb750:
we have purchased a 400/4 here in Oz that originated in the UK (# XYF93T, yellow - if anybody knows it I would be glad to hear from you) mostly for the wife to run as it suits her size etc. Very good condition, good fun (bike that is!). Something somebody might be able to help with - it's very hard to get into neutral if there is a short wait after pulling up - normally need to slip the clutch and get some movement and try that way, then of course it goes too far and into 2nd, and the same problem arises. Have even resorted to turning off and wrenching it by hand. Any tips??
I also purchased a 750/4 that had a small problem and had a posting on the 750 site a couple of weeks ago - for those that remember - yep, it was a ring! Bugga.
Cheers
Peter.

SteveD CB500K0:
Very common problem for which there is no real fix other than making sure the clutch is adjusted properly.

I always \"snick\" into neutral as I pull up - it's a habit that I've aquired over the past 30 years!

jimshea:
Yep mine does it... I engage neutral whilst moving, or sometimes, a few revs can help to engage neutral.

petercb750:
yes this is what we have resorted to. Can be a real struggle tho at times if you forget before pulling up. The 750 is a bit the same. Having ridden modern bikes for many years I'd forgotten the little quirks of the older ones - but it is nice to be back on bikes with virtually no plastic!

JonnyB:
That's the way it should be, there's nothing worse than dropping a bike bike while trying to turn it round, then finding out youv'e done

Navigation

[0] Message Index

[#] Next page