Other Stuff > Tricks & Tips
Piston ring clamps..
Jimbo550:
currently rebuilding a cb550 f1 engine and got the the stage of replacing the barrells today. I don't have a set of piston ring clamps small enough for these pistons and didn't want to wait a few days while i ordered some so i set about making some from a bit of plastic. I cut up an old ice cream container into strips which wrapped around the piston rings and then used a cable tie to secure it in place. So simple so cheap and worked a treat. Thought i'd share it as it may help someone else out one day.
UK Pete:
That is very creative, i have made a mental note incase i need to use that idea
Pete
matthewmosse:
Good idea, might save me easing them in with my thumb nails.
Seamus:
Pretty neat. I have used jubilee clips before and they worked OK, but must confess to using small screwdrivers and fingers etc
bomber:
Nice one, going to do this tomorrow.
Thanks
Navigation
[0] Message Index
[#] Next page
Go to full version