Author Topic: 650 cafe progress.  (Read 2212 times)

Offline RickyC83

  • SOHC Associate
  • Posts: 75
    • View Profile
650 cafe progress.
« on: March 23, 2013, 06:35:50 PM »
Finally got some time to start working on the frame today.
De-tabbed cut the rear end, made a plate to house battery and electronics.
Nice to feel like I've done something to it wish work wasn't so crazy.

Offline RickyC83

  • SOHC Associate
  • Posts: 75
    • View Profile
Re: 650 cafe progress.
« Reply #1 on: April 12, 2013, 11:17:42 PM »
Started trying to make a seat unit.

Offline RickyC83

  • SOHC Associate
  • Posts: 75
    • View Profile
Re: 650 cafe progress.
« Reply #2 on: April 12, 2013, 11:18:28 PM »
But my fiber glass dosnt seem to be hardening :-(
Will see in the morning

Online SteveD CB500K0

  • Administrator
  • SOHC Jedi
  • Posts: 4444
  • Ride on the Steel Breeze...
    • View Profile
    • Steve's Blog
Re: 650 cafe progress.
« Reply #3 on: April 13, 2013, 09:30:56 AM »
In my (limited) experience that was due to either the ingredients being old or the temperature too low.
2022 Tiger Sport 660
1971 CB500K0

Offline UK Pete

  • SOHC Jedi
  • Posts: 2696
    • View Profile
Re: 650 cafe progress.
« Reply #4 on: April 13, 2013, 09:37:32 AM »
Yes the temperature has a lot to do with it and the correct amount of hardener,
what did you cut your foam with?

Offline stuartni

  • SOHC Member
  • Posts: 169
    • View Profile
Re: 650 cafe progress.
« Reply #5 on: April 15, 2013, 10:29:29 AM »
looks great so far   8)

Offline RickyC83

  • SOHC Associate
  • Posts: 75
    • View Profile
Re: 650 cafe progress.
« Reply #6 on: April 15, 2013, 02:09:01 PM »
Terns out I didn't use the right amount of hardener. So it never set.  (Idiot)

So started again and this time it went well. Had about a litre and a half of resin and 4 layers of glass fibre. It's pretty strong now.


Offline RickyC83

  • SOHC Associate
  • Posts: 75
    • View Profile
Re: 650 cafe progress.
« Reply #7 on: April 15, 2013, 02:10:20 PM »
Yes the temperature has a lot to do with it and the correct amount of hardener,
what did you cut your foam with?


Used a surated kitchen knife to cut the foam (got in to trouble for that BIG TIME)
Then sandpaper to smooth it out.

There's a vid on utube by dime city cycles on how to do it

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal