K1 rear wheel bush

[dieffe]

I have discovered another problem with this rebuild. I got the bike in bits and inevitably there are bits missing.
What I have found is that I am missing a bush/spacer that sits between the sprocket carrier and the wheel (item 13)
If anyone happens to have their bike apart and could measure one for me so that I could get one made that would be fantastic.



If anyone happens to have a spare one they could sell me that would be even better. 

Thanks in advance.

Dave

[RGP750]

Hi
I will look at the parts list when i get home but the
one on my K0 is plain not stepped and is 33.96mm od 20.08 id and 18.26 mm thick.
Rich

[RGP750]

Sorry scrap the last reply i was looking at number 9 ,i'll try and sort it
tomorrow
Rich

[RGP750]

Hope this is the right one.
Rich

[dieffe]

It doesn't get much better than that, that is absolutely brilliant, thanks very much Rich.
One more thing though, I may as well be ultra cheeky, what material do you think I should make it out of, mild or stainless?

[mike the bike]

It's great the help we get from fellow members,  I went on the Katana forum to ask if someone could measure their tank decal for a GS650G.  I didn't get one single reply.

[RGP750]

Either really as it is out of sight.
I will check tomorrow to see if it has been hardened,meant to do it today
but customers got in the way.
Rich

[dieffe]

It's great the help we get from fellow members,  I went on the Katana forum to ask if someone could measure their tank decal for a GS650G.  I didn't get one single reply.

I had exactly the same thing on a Kawasaki forum. I needed some info about my 1100 Zephyr and got absolutely nothing back. 

[RGP750]

Hi the bush is not hardened.
cheers Rich

[dieffe]

Thanks again Rich, mild steel it is then. 

[dieffe]

Got one made, thanks again for your help Rich.

[RGP750]

Looks good.
another bit nearer 

[Bitsa (Ralph Wright - RIP)]

Does look good but Rich would have done it in his sleep going on the one he made me,
Cheers
Bitsa