Honda-SOHC
SOHC.co.uk Forums => CB750 => Topic started by: Phil9886 on July 05, 2020, 01:12:03 PM
-
Hi. Hoping someone can help me. I'm at the very end of a restoration project on a K6 and tried to fit the disc cover - but it fowls on the disc. The disc appears to be the right size as it just reaches the top of the pads. I'm wondering if I have a pair of CB 400 lower fork sections - which could have the mounting brackets for the cover in a slightly different place? Or am I missing something easy? Everything else appears to line up / bolt on perfectly.
-
Or even fouls :-)
-
Or even fouls :-)
Come on.
That's a poultry complaint
Sent from my SM-A750FN using Tapatalk
-
It should go on the large bolt at the lower end of the pivot pin
-
Yes - that's where I'm trying to fix it. The more I look at it the more I'm thinking I've got 400 forks on it. Does anyone have a measurement from the center of the front axle to the point where the rubber gator starts on the the LHS lower fork section? That would be really helpful. Thanks. Phil
-
Is there a caliper mounting on the other slider?
-
Yes there is. It came with a twin disc conversion - I've left the RHS disc off. So I guess it must be a set of 750 forks. Maybe the disc is non standard and diameter slightly too large? Anyone know what the diameter of a standard disc is? Thanks again. Phil
-
Not off hand. Are you sure the cover is off a 750?
-
Yes. Bought from CMSNL. There was no cover on when I bought it though. I'll check the disc diameter. That's likely to be the problem. Cheers. Phil