Honda-SOHC

Quite right too, Mick dogs are part of the family 👍
I'm waiting for my carb kits now, I've got a starting point by balancing the carbs and it will tick over smooth at 1100 rpm but to get it to rev cleanly and idle the mixture screws need to be almost out. I'm pretty sure it's the float level masked by the worn needle springs and possibly also the slow jet which might have been cleaned with a wire...both hopefully sorted with the carb kits

I've contacted the tool provider who supply the same tool to DS. It appears that the supplier for the retainers were the issue. I've been offered some turned down pins as an option for my tool. I will contact DS and see if they can supply a better part. The rear tool is a different design to the front one.

Still got the VFR800 for sale here


Sent from my iPhone using Tapatalk

On my original 400/4 I zip tied the box on the top frame tube and just clear of the carb bank as there was just enough room for it to sit between the fuel tank tunnel and the frame tube. I thought I'd had a result until one day when giving the bike a handful it topped out at 110mph🙄, (actually it was about 70!). The CDI box had slowly worked it's way back down the frame just enough to interfere with the top of the carbs at full throttle.
I'm 90% sure the Boyer does use a wasted spark Ash👍

Apologies I can’t make it after all have been asked to help out at a police Bikesafe event. Next time.👍

No worries 👍