Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Trigger

Pages: 1 2 3 [4] 5 6 ... 15
46
Project Board / A RUF 750
« on: July 25, 2018, 09:01:49 PM »
I bought this off ebay about 3 years ago, as a K6 rolling chassis. JustcallmeMrT and myself went to pick up the bike from a dodgy council estate in Slough. The guy was operating a  bike beakers from inside his house and the rolling chassis was with a pile of other bikes and bits in his front room.
I turned up with a corsa and a hand full of tools and, we set to stripping it down on the drive and piling the parts into the back of the corsa so, no pictures of when i laid my hands on it for £350. Amazingly the bike was register in March 1977 and the last time it was taxed was August 1983, then left to rot.
It has been a long time getting it to this stage as work always got in the way and a few problems with the clutch and it sumping, even though the oil pump was rebuilt along with the F1 engine, which i had as a spare.
So what we ended up with in the end was a old school look to a K6, with F2 tank and clocks made up from parts i had laying around.
She finally had her maiden voyage tonight.     

49
CB750 / Clutch plate confusion
« on: July 12, 2018, 02:13:50 PM »
EBC site lists the 750F1 kit as CK1220 and the 750k6/k7/F2 kit as CK1145. I have worked on many of these bikes for more years than i can remember and i know that the F1 and K6 have the same basket, all plates the same apart from the outside one which has the bigger tabs.
I now regret binning my clutch charts away many years ago and no good phoning any suppliers, as all you get is "that what my computer states"  >:(
Look up the OEM PN and it has been superseded more times than i have had hot dinners so, you don't even know if it the right size anymore. CMSNL even state that it also fits the 550, it can't because the ID size is well off.

So after a whole morning putting EBC to rights (and it would of gone in one ear and out the other). Has anyone got a old clutch plate chart ?
The plate i require is ID 120, OD 140, 12 tabs and 16mm wide tabs. This is the one and only plate i require    ;)

50
Misc / Open / For all the interested plane enthusiasts
« on: June 29, 2018, 10:10:15 PM »
26 Typhoons scrambled from Coningsby today in 11 minutes, not sure if a drunk was on a easy jet flight on its way back from Ibiza  ;D ;D ;D


https://www.youtube.com/watch?v=oYD3Ufo8SHY

51
CB750 / F2 tank with K6 carbs, problem
« on: June 02, 2018, 01:19:02 PM »
Just finishing off a little project and came across a problem. The fuel tap on the F2 tank fouls the choke lever once the fuel pipe is on. I know on the F1 the tap had a rear fitting for the pipe but, though I have a F1 tap, it is a different thread. Have tried a reverse outlet tap but, the pipe bends up against the rocker cover.

Anyone come across this problem before and any ideas on how to get round it ?

[ Guests cannot view attachments ]


[ Guests cannot view attachments ]


52
Project Board / Bitsa Project
« on: May 04, 2018, 07:52:10 AM »
This started life as the ropiest K3 I have ever seen, now the only original parts that are K3 is, the frame, forks and wheel hubs. The rest is what I had laying round, donated by forum members and bought.


[ Guests cannot view attachments ]



[ Guests cannot view attachments ]

53
CB750 / Don't see many of these UK ones about
« on: March 11, 2018, 08:02:52 PM »
Nice Honda picture, can't make out the date on the tax disc. Looks like it was taken just off Trafalgar Square, just at the entrance to the Cockspur Street me thinks  ;)


55
CB750 / 300's with short skirts
« on: January 25, 2018, 11:01:08 PM »
I thought the short skirt bit would get attention  ;D ;D ;D
I must of built over 120 CB750K engines in my time but, never have I come across this before. The one on the right is correct and both marked Honda 300.




56
CB500/550 / Anyone looking for a $9000 engine
« on: January 23, 2018, 06:23:53 AM »

58
Misc / Open / Silicone Brake fluid
« on: January 15, 2018, 02:49:43 PM »
Have had someone ask me to service his brakes but, they are insisting that I use DOT 5. My supplier only lists 5.1, is there any difference ?

59
CB500/550 / It all happens on a sunday night
« on: January 07, 2018, 07:10:23 PM »
Check out the oil filter bolt, I am off to Hull on Tuesday, may go and view it  ;D >>> https://www.ebay.co.uk/itm/honda-cb550-f/152857063644?hash=item2396fdb0dc:g:bN0AAOSwHYVaUksh

60
Misc / Open / Original rust in a can
« on: January 06, 2018, 10:27:15 PM »

Pages: 1 2 3 [4] 5 6 ... 15
SimplePortal 2.3.5 © 2008-2012, SimplePortal