This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Topics - Glynnrg
Pages: [1]
1
« on: July 08, 2017, 04:08:36 PM »
Seem to have oil weeping from this nut on the back of my 550f can anyone tell me what it does?
2
« on: July 02, 2017, 11:46:48 AM »
Is this a standard set up for indicators on a cb550?? It's the first I've seen Ike this
3
« on: June 25, 2017, 06:11:36 PM »
Anybody recognise what bike this grab rail might be from it came in a box of bits for a cb550 but it's not one I recognise so I'm a cb550 grab rail short
4
« on: May 21, 2017, 07:42:16 AM »
why cb550f1 the third exhaust not getting hot I presume this cylinder isn't running properly plug seems to be getting wet when I pull plug cap of engine dies slightly tho sparks on all plugs don't seem that bright but not knowing what they should look like don't if this is normal Anyone got any ideas
Thanks
5
« on: December 31, 2016, 09:37:48 AM »
Morning to all
I have removed the carbs and cleaned fitted rebuild kit the rebuild kit came with 3 small rubber o rings not sure where they went and looking at other rebuild kits u could get they wernt always included (so didn't fit them)
Before I fitted them back on the bike I put petrol through them on the bench one of the carbs is still leaking via the overflow is this the norm or have I still got a problem
Any ideas what could be causing this and any solutions
Ps the floats don't seem to be sticking
Many thanks and a happy new year
6
« on: April 28, 2016, 08:43:24 PM »
Before redex sticking floats leaky carbs unable to idle below 1400rpm
After redex no sticking floats no leaky carbs ticking over lovely
well worth the 6 quid!!
7
« on: April 12, 2016, 08:32:35 PM »
Tell me if I'm draft but does anyone use redex in there bike?
8
« on: April 12, 2016, 06:30:22 PM »
I have got a passing light integrated on the horn switch of my 550f1 is this correct for this model?
9
« on: April 06, 2016, 03:44:07 PM »
Long time since I've had a bike with a single pot calliper should you be able to pull the lever virtually right to the grip?
Recently stripped the calliper cleaned it up put in new seal and new washers on the banjos and bled it through dosnt seem to be any air in the system but the lever seems to pull in a long way?
10
« on: March 19, 2016, 09:04:21 AM »
Can anyone tell me what bike this might be from got it with boxes of cb 550 bits
Cheers
11
« on: March 13, 2016, 10:11:47 PM »
Recently bought a 1977 cb550f in bits has frame number 1027134 and engine number 1142210
Some of the parts are duplicated but some look they could be from a f1 and some from a f2 I though because it's a 1977 it would be a F2 but now not so sure anyone got any ideas
Thanks
Pages: [1]
|
Show Posts