211
CB750 / Taper head race bearings.
« on: August 15, 2014, 05:37:55 PM »
Hi. Bit of advice required if somebody could oblige. Am about to change the head race bearings on my 750F2 for taper bearings. Have bought a set that has the two races (fairly obvious which is top and bottom due to the different sizes). My kit also came with a large steel washer. Does anybody know where this washer goes. I assume it's there to build up the stack height to match the original ball races. My guess is that it goes underneath the bottom race on the yokes, but it is only a guess. Help Ta.