91
Project Board / Re: Teds new project a CB500 K1 mostly version 0.5 circa 1972.
« Last post by McCabe-Thiele (Ted) on May 01, 2024, 03:21:18 PM »I've contacted the tool provider who supply the same tool to DS. It appears that the supplier for the retainers were the issue. I've been offered some turned down pins as an option for my tool. I will contact DS and see if they can supply a better part. The rear tool is a different design to the front one.
Update DS have tried their tool in the three retainers they have on the shelf - one does not fit the tool. They will not send me a replacement part until they have recived my part back and tried it in their tool!
Update DS have tried their tool in the three retainers they have on the shelf - one does not fit the tool. They will not send me a replacement part until they have recived my part back and tried it in their tool!