Honda-SOHC

not sure where these came from think my dad made them ?

8mm socket welded onto bar..... what was he doing ?

also the curved tool ?

cant recall where 2 of these go

got 4 of these 2 large ones which I have pushed onto sides of frame

as in no 12 here

http://www.cmsnl.com/honda-cb550k3-four-england_model14671/partslist/F12.html#results

I have 2 more .... cant recall where they go though

anyone tell me where other end connects to, both ends had a clip

so one to bottom of tank other one ?

how would i go about sorting this, sheared off and bolt is just below being flush ( 1mm ish under being level )

not a big bolt length wise 10mm, I would say 8-9mm in the fork, need some advice to  fix

meant to be for a k but not so sure could do some side by side with my k

spoke to a couple of members who have what I assume is a different set up to what I have

attaching the throttle cables to the pulley on top of carbs

on what I have seen pics ( 500 and 400f ?) of the cable nipple go into 2 holes on the same pulley one to open and one to close

on the k3 I assume its different

ie one goes into pulley other one goes into a cradle that swings up

so am I correct and if so does the cable go under the carbs or as I have it now over the carbs

also cable route correct ..... under rpm, down the left hand side of bike


pics

route first

through the rpm counter



down the left and onto the carbs





now this place for fitting the cable on top of carb

I hope in this pic you can see where I think it goes different to other 550s and 500s ?



pic showing what I am trying to connect



and lastly connected into this cradle but the wire going over the carbs which I am not convinced is correct so thought I would ask

SORTED TA