This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - MikeM
17
« on: September 29, 2014, 08:49:00 PM »
unfinished project
18
« on: September 04, 2014, 06:49:36 PM »
what about oiling parts etc
19
« on: September 04, 2014, 12:59:53 PM »
about to replace the cylinder head any tips ?
just cylinder head and cover
20
« on: August 16, 2014, 08:56:04 PM »
well head is off I think it was just catching on the threads, plus I missed one washer in the middle of the head ( recessed ones )
21
« on: August 16, 2014, 08:54:32 PM »
from what I can tell once you get a smooth ring on both faces your good to go ?
also does the part the valve slides into need to come out ? original head has new stem seals
valve guides ?
22
« on: August 16, 2014, 08:30:36 PM »
because its my first time going to use something that easy going, seen the drill video on youtube but don't fancy myself with that
23
« on: August 16, 2014, 10:25:54 AM »
changing this head of mine
is it simply a matter of cleaning up faces for the new gaskets ?
also valves after lapping in do the valves have to go back into same place from old head
24
« on: August 12, 2014, 10:49:09 PM »
it prises up carb side more, could be snagging on threads.... try again tomorrow
25
« on: August 12, 2014, 10:04:59 PM »
took of the 12 nuts that hold down the head, took out tensioner bolt...... and allen head bolt
now it prises up 3-5 mm and gets caught on something
anything I have missed, cant seem to see anything else
26
« on: August 11, 2014, 02:46:45 PM »
27
« on: August 10, 2014, 07:36:01 PM »
2 questions
are they the same stud either side of cylinder head
also best way to remove studs without snapping only need a couple each side for replacement head
28
« on: July 21, 2014, 12:56:27 PM »
drop us a link to them ones would you please mate, sound just what I am after
29
« on: July 21, 2014, 09:25:52 AM »
anyone? got a guy making me some brass bushings
30
« on: July 20, 2014, 02:46:11 PM »
anyone got the dimensions for the plastic swingarm bushings.... main one that main bolts slides through?
550k3
|
Show Posts
