Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mo goldie

Pages: [1] 2 3 ... 11
1
The Black Bomber Board / Re: 67` Bomber running problems
« on: Today at 04:16:48 PM »
can anyone supply the following .....as a bloke has asked if I can supply them he will see what he can come up with if anything ?

so he said if you supply me with the diameter of the centre hole and the p.c.d. with hole diameter and the number of holes and the chain pitch

well I Know it is a 530 pitch chain but Not the other bits  ;D

2
The Black Bomber Board / Re: 67` Bomber running problems
« on: Today at 03:49:24 PM »
Hi Guys

yes it is a big ask to try the 17T front just wanted to bring the revs down as its doing about 6.000 rev`s at 55 mph so was just going to try that set up...... But ha ho can`t even get a rear sprocket..... I am Not a Rich man ..... and about a £100 + P+P for a sprocket is just Dam robbery....... Like you say Ash they must be someone doing an after market one... BUT I can`t fined one  :'(

 PS, I am Not used to the high Revving Honda :)

3
The Black Bomber Board / Re: 67` Bomber running problems
« on: May 17, 2024, 06:26:52 PM »
Hi

yes it is 35 std so would like to get one of them..... I don't know what it will pull like as I got a 17T Front one to go on and std is 15T so will have to see...... just need to get a 35T rear.

4
The Black Bomber Board / Re: 67` Bomber running problems
« on: May 17, 2024, 03:38:36 PM »
Hi Everyone


Well been trying to find a rear drive Sprocket for the Bomber but can`t seem to get one  ::) I have a new front one and a new chain. but do anyone know where to buy one from DSS has none  :'(


5
The Black Bomber Board / Re: 67` Bomber running problems
« on: May 01, 2024, 06:48:16 PM »
here we go again  :-X

Well been trying all day to get a better running Bomber...... it misses sometimes and it pop`s on the over run well most of the time it doo, I have this morning taken off the cam covers and re-done the Valve clearance`s also looked again at the ign Timing checked out and re-gaped the plugs also set the mixtures using a colour tune which I got to a Nice Blue colour, the other thing I thought about is if there was a leak in the exhaust somewhere........... I still wonder if it is running rich or lean around that 1/4 throttle opening ?

Weather being kind i`ts the vintage run on sunday....But I keep Trying to sort it dont no what else to try ?  ........... don't know if its still something to do with the Kits that Ashely said about ....... and Main Jet by the way is the standard 125 ...but I have not got any bigger ones to try if it needs to go that way LOL  ;D

6
The Black Bomber Board / Re: 67` Bomber running problems
« on: April 20, 2024, 10:23:37 PM »
Thanks Dave

yes that was the best result of the day................. Dam Scooters lol But well chuffed Thanks  ;D

7
The Black Bomber Board / Re: 67` Bomber running problems
« on: April 20, 2024, 10:11:57 PM »
Hi Guy`s

Just an update..... well after it rained and I thought I would Not Take the Bomber to the show rain all cleared up by 10;00 am so my mates on there CL305 and CB77 super hawk got to the show...... had a Great day None of us won anything tho as the scooter lot seemed to win it all ( yes well what can I say :) )........... but ha ho the main thing I have to report is that the Bomber went like a dream, as the other day when I took it out it kept missing and that 4,000 rev`s problem was there............ well I messed about with the Carb`s and the plugs I had set at 30 as book say between 28 - 32 so had them at 30.....so changed them to 28, well what can I say....... I am leaving everything as it is as I say it went like a dream No missing and the 4,000rev`s  it did not even have a hiccup anywhere Now ..... so as I say if it runs well don`t fiddle ha.

cheers Mo

8
The Black Bomber Board / Re: 67` Bomber running problems
« on: April 16, 2024, 06:51:05 PM »
Yes thanks it is good news after all the problems I have Had..... but thanks to all you Guy`s on the Honda Forum and Ashley who has helped me out big time and hope he can help out on the last thing I require to finish it right off is the Carb kits that he said back in the day to sort out that Dam Flatspot at the 4,000 rev range.... as he said them at the DSS did Not even Know about them even when he sent them the info for them either  :-\ ..... But hope Ash can find some out there for me I will be well chuffed.... I also will put some pictures on here when I do get her out for some shots.

Thanks all

Mo   

9
The Black Bomber Board / Re: 67` Bomber running problems
« on: April 14, 2024, 06:19:34 PM »
Hi K2-K6

well it was a steel washer up against the oil seal and held in by the Circlip. I have been on it today and fitted all the new springs Etc... and it all done as far as I can go as just waiting for that rear Tank Rubber if I can make that fit too, as I can`t get one of the ones that it is meant to have as I did Not even know it was meant to have one till I looked in the Manual, so I can put the tank back on and then Try it out ... ( weather depending tho ) good bloke Ashley is going to see if he can get any of the old Carb kits he had a while ago from people who had more than they Might have needed so that will be really good if he can...... so fingers crossed Ha

and I should be able to get to the show Next weekend  ;D

10
The Black Bomber Board / Re: 67` Bomber running problems
« on: April 13, 2024, 10:02:50 PM »
Hi Again

Well Panic over...... it is indeed just a circlip and washer on the sprocket side that holds the shaft in as just watched a YT video
of the CB450 and they put the Gearbox all in and the bottom half of the engine casing on and then put the gearshift in last... Wow thats a load off my mind ha........ so tomorrow I can go in the workshop and hope to get it all back on .......  ;D

 

11
The Black Bomber Board / Re: 67` Bomber running problems
« on: April 13, 2024, 08:23:08 PM »
Yes there is a picture on Ashley's workshop manual thats shows the same as the circlip looks like it is on the left hand side near the Sprocket, so I will take that casing off tomorrow and have a look if it is the circlip on that side I should be ok............Be a load off my mind if it is that........

I will update tomorrow.

 

12
The Black Bomber Board / Re: 67` Bomber running problems
« on: April 13, 2024, 03:30:36 PM »
Hi everyone

Well lets start off with some good news... all the parts turned up today from DSS..... so thought well I have a week to the show so I will make a start and get them all in..... all was going well as removed the clutch and oil pump etc, put in the new Detent first all fine then thought oh need to remove the gearshift shaft to put the new spring on so taken off the gear leaver  and started tapping it though did not think anything was holding it in so I am sure I heard something in the gear box rattle as tapping it out so stopped where I was....... SO OH dear is it me or have I done something I should not have done ? 

please say keep Knocking it out as that was the gears rattling around..........(Bet its NOT MY LUCK tho) as if Not I give up like Ashley said thought I had just got a restored Bike :) I may have been better getting a Basket case the Amount of work I have done on it.... thought I was Nearly all there ...... if you say the Engine has to come out or at least got to split the bottom off I will just give up I Think...as just Not had Much luck ha  :(

13
The Black Bomber Board / Re: 67` Bomber running problems
« on: April 12, 2024, 10:48:30 PM »
Hi

Well I am using standard NGK B8ES ones.

14
The Black Bomber Board / Re: 67` Bomber running problems
« on: April 11, 2024, 07:33:46 PM »
Hi Ashley


Well yeah it was meant to be all done but as we know there is restored and just Tried too ha I got that one  LOL.

I made a tool up today just like the one you showed.... Not much of a good bit of welding as I only have one which don't use Argon gas so it is spits and spatters  ;D But Ha Ho it done the Job so got one off try the other tomorrow and yes heat was needed too the heat that is.

If you can get any of them kits Ash I would be most Grateful.......  A Bit of a B*gger to hear that at that 4.000 res they had the problem ha just as Mine seem to just not want to get up and go and when you are in todays Traffic and need to get away it just go`s dead is Not good........... so anything that will Help id most Grateful.

Cheers

Mo

15
The Black Bomber Board / Re: 67` Bomber running problems
« on: April 10, 2024, 11:44:01 PM »
oh also having trouble getting the fork seal holders undone .......... i don't want to get and spend out on a tool that I will most likely only use once ha..

and i nearly got a rear tank rubber a New old stock one for £19 but they would not ship it over............ also don`t know how it will go but put two old needles in the carbs what I found in the old parts that came with the bike which I did Not even know about, they are a little bit longer than the ones what came in them kits so don`t know what it will run like.......... but got to sort out them fork oil seals first as the mrs keep saying she fed up with washing my jeans out of the blow back of oil...... I thought you want to see the bike that's more important   ::)

Pages: [1] 2 3 ... 11
SimplePortal 2.3.5 © 2008-2012, SimplePortal