Recent Posts

Pages: [1] 2 3 ... 10
1
CB500/550 / Re: Swinging arm bushes
« Last post by Laverda Dave on Today at 05:51:11 PM »
Yes you do Steve. They are dust seals and they also have a rubber seal on the inside to keep the swing arm grease in.
2
Misc / Open / Re: Advice sought, modernish tourer needed
« Last post by Laverdaroo on Today at 05:46:47 PM »
Top man, the trumpets are great bikes, fingers crossed you find the dosh and get you’re new whip


Sent from my iPhone using Tapatalk
3
CB500/550 / Re: Swinging arm bushes
« Last post by SteveW on Today at 05:39:42 PM »
I have a set of the bronze bushes from Julie I’m about to install.
Do I still need the caps, item 15 in the picture?
4
CB500/550 / Re: 1975 CB500K1 crank rotation resistance
« Last post by martin_uk on Today at 05:33:15 PM »
Quote from: McCabe-Thiele (Ted) on Today at 10:53:41 AM
Does the crank have that free movement feel if you make a very small rocking action with the crank?

Do you have any doubts that the crankcase halves were a factory pair?

I will check for end float.

Pretty sure halves original
5
Misc / Open / Re: Digital Speedos
« Last post by DomP on Today at 05:32:39 PM »
🤣 so I ended up ordering my speed sensor from Digital speedos, it was the only place in the UK I could find the Honda version
6
CB500/550 / Re: 1975 CB500K1 crank rotation resistance
« Last post by martin_uk on Today at 05:23:34 PM »
Quote from: Bryanj on Today at 01:22:38 PM
You didnt oil the back of the shell did you?
no, but good point.
7
CB750 / Re: WTF Exhaust
« Last post by paul G on Today at 02:01:18 PM »
Quote from: AshimotoK0 on Today at 01:40:27 PM


https://youtu.be/i31ukMWH9oY

Also 400/4 that sold £1500  not sure if provisional though

https://www.youtube.com/watch?v=ok-KWZRJ1m8
Ash I think that sold as the guide was £1500-2000 bargain at £1500
8
CB750 / Re: WTF Exhaust
« Last post by AshimotoK0 on Today at 01:40:27 PM »


https://youtu.be/i31ukMWH9oY

Also 400/4 that sold £1500  not sure if provisional though

https://www.youtube.com/watch?v=ok-KWZRJ1m8
9
CB500/550 / Re: 1975 CB500K1 crank rotation resistance
« Last post by Bryanj on Today at 01:22:38 PM »
You didnt oil the back of the shell did you?
10
Misc / Open / Re: Sump gasket...what to think?
« Last post by Laverda Dave on Today at 12:56:09 PM »
I just use normal grease, no fancy high melting point or copper grease just the same grease I use for bearings and swing arm bushes etc.
Pages: [1] 2 3 ... 10
SimplePortal 2.3.5 © 2008-2012, SimplePortal