This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Ashdowner
16
« on: February 09, 2018, 02:42:04 PM »
Hepolite used to make pistons and rimgs for just about every bike you can think of UK and Jap.
17
« on: February 09, 2018, 08:10:03 AM »
Can anyone please tell me the best match in black 2K paint for a 1965 Honda CA77??
18
« on: December 16, 2017, 08:26:20 AM »
Is the choke cable and the choke actuating screw on the carb shaft properly adjusted?
19
« on: December 16, 2017, 08:22:51 AM »
Put the Boyer back on. I had it on a previous bike and it was superb. Prob going to get it for my current bike.
20
« on: December 11, 2017, 07:29:49 PM »
Change all your other lights to LED's and you can just about have any headlamp you want, but I've got a Philips Eco H4 which gives out about 25% more than a standard H4
.
21
« on: November 30, 2017, 07:46:25 PM »
Try the CB550 model guide on the info part of the SOHC website
22
« on: October 18, 2017, 09:32:22 PM »
Yep can confirm from experience the dating letter from the VJMC is the way to go.
23
« on: October 16, 2017, 09:22:11 PM »
But if it's a CB500 seat then am I right in thinking that it will only fit the CB550 K0, K1 & K2? The CB550K3 and F tanks have a different profile at the back and if a K3 or F tank is used on an earlier model then the seat will press hard on the sides of the tank and rub the paint off.
24
« on: September 25, 2017, 11:46:18 AM »
I have a tank that I'm going to put on ebay next Sunday. Fits K3,K4, F1-F2 (Don't know about F3). Solid. Small bits of surface rust. 2 dints that hardly show on the photos - both fillable but one may pull out. Inside bright shiny steel.
25
« on: September 25, 2017, 11:01:06 AM »
£270 a joke, but frustrating that it has the side panel that I need.
26
« on: September 25, 2017, 10:52:57 AM »
Yes someone I know just had it done. It's not a helicoil but a solid insert, and it's done very carefully so no crap ends up in the barrel.. dougie@thethreadmaster.co.uk 07775510166 is a guy in Hampshire who did it for him in Sussex, but there will be someone local to you who can do it.
27
« on: September 17, 2017, 09:05:20 PM »
Both my spare K3 tanks are 10.6cm or as close as I can measure them
28
« on: September 17, 2017, 08:00:45 AM »
I've got DR7ES plugs with resistor caps so I suppose I'm completely wrong, but strangely that's what David Silver sells
29
« on: September 14, 2017, 12:22:16 PM »
Why is having the headlamp on infuriating? At least you can be seen. If it's a power problem then replace your stop/tail and indicators with LED's (inc LED relay) and get a Phillips eco H4 for your headlamp.
30
« on: September 11, 2017, 09:56:09 AM »
I think Seabeaowner has the answer. As for the clutch swap I'm sure someone posted a few months back that they'd done it.
|
Show Posts