This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Pauarc
Pages: 1 ... 3 4 [5] 6 7 ... 14
61
« on: November 22, 2023, 02:11:15 PM »
Yes that was my thought too so clutch cover coming off again and remove bearing holder select end and clutch so I can poke something through and blow it through with the air compressor looks like my weekend is gonna be taken up on the bike hopefully I find something blocking passage way
62
« on: November 22, 2023, 09:45:53 AM »
Yes it’s rubber and still pliable, and it has a groove round it Like a top hat
63
« on: November 22, 2023, 09:32:26 AM »
Just had a Quick Look at plug came straight out with no problem. No damage just had a little bit of sealer on the end turned over on start motor oil comes straight out see picture will have a proper look at the weekend and check the bearing outlet through to the clutch
64
« on: November 21, 2023, 07:44:41 AM »
Hopefully l have time at weekend to look at it I will keep you updated thanks for help
65
« on: November 20, 2023, 07:34:21 PM »
There is a good return to oil tank so hopefully may be that?? Keep fingers crossed 🤞
66
« on: November 20, 2023, 07:13:50 PM »
The plug may be worth a look if the plug is removed I could see if oil is there if I spin on starter motor
67
« on: November 20, 2023, 06:08:56 PM »
I have changed the oil seal under bearings plate not sure if this is the plug
68
« on: November 20, 2023, 05:41:02 PM »
Took clutch apart again no oil in central hole bike is a cb750k2
69
« on: November 20, 2023, 02:11:28 PM »
Does anyone know what the hole in clutch centre is for
70
« on: November 20, 2023, 11:35:14 AM »
Just fitted a test oil gauge and idle pressure seems to be about 35psi and at about 3000 to 4000 it is about 60psi this is with the engine hot just can’t understand why clutch drags so much (help me)
71
« on: November 19, 2023, 08:39:54 AM »
Just run bike with the clutch cover off I don’t think it’s getting any oil to clutch the clutch is quite dry is there anyway I could check the oil feed pump seems to return oil to tank ok
72
« on: November 08, 2023, 08:34:37 PM »
Does anyone know what size thread the oil switch is
73
« on: November 07, 2023, 08:29:46 PM »
I have looked at the outer basket and it had a bit of pitting where the friction plates run I run a fine file over them also I noticed that the new friction plates had sharp edge so I filed them off have to see if that helps
74
« on: November 02, 2023, 08:27:10 PM »
The spacer is in there as charged stoper ring thanks Skoti
75
« on: November 02, 2023, 04:06:28 PM »
I just looked on bike cover still off I see what you mean but the front and back line up spot on also there’s alignment Dowls I just think it’s the clutch dragging going to strip the clutch again and look at basket as Martin spotted marks on the outer
Pages: 1 ... 3 4 [5] 6 7 ... 14
|