This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Athame57
Pages: 1 ... 76 77 [78] 79
1156
« on: September 10, 2018, 06:30:05 PM »
Nine Nine Nine!
1157
« on: September 10, 2018, 05:28:20 PM »
MCTID...nine..nine...der are more zan ten available!
1158
« on: September 09, 2018, 11:45:08 PM »
YA! YA! But himmel...£999.00 ? How many Euros is that?
1159
« on: September 09, 2018, 07:28:03 PM »
1160
« on: September 09, 2018, 07:27:09 PM »
 HA! HA HA!
1161
« on: September 09, 2018, 11:15:50 AM »
...Hi Julie
While I was away I began getting sceptical too and even emailed the webmaster. Bad as fake news, next time I'll sniff around asite a bit more before I share a link!
1162
« on: September 09, 2018, 02:41:53 AM »
1163
« on: September 06, 2018, 03:19:12 AM »
Looks great! 
1164
« on: September 04, 2018, 05:00:38 PM »
Me and my bezerko RG500 at the Cutty Sark in 1987..
1165
« on: September 03, 2018, 07:47:31 PM »
I'm soon to acquire a new petrol tank and side panels and also the decals for my red CB400F2. I want of course to get them painted and decals fitted, what I want to find out is a good place to get the work done in greater London ....suggestions?
1166
« on: August 29, 2018, 12:13:35 AM »
I had exactly the same problem with my CB400F2 from the moment I acquired her. First gear selected ok until the engine warmed up after a few minutes then nearly impossible. All other gears were unaffected. I imagined I had a crank splitting job ahead of me. Then I discovered that simply by adjusting the gear shift lever a little had the problem solved!
1167
« on: August 27, 2018, 10:36:51 PM »
Thank Julie ...just ordered some 'red rubber grease'! 
1168
« on: August 27, 2018, 10:09:51 PM »
I'm soon to lift the rocker cover on my CB400F2 for polishing and have purchased a new gasket/packing for it ahead of that. I see it is of the rubber tube type that will fit into a groove. Do I need any sealant for this item. I have Loctite Flange sealant MR5922 handy.
1169
« on: August 23, 2018, 04:35:28 PM »
I don't know. The silencer isn't original though...
1170
« on: August 22, 2018, 10:12:26 PM »
I just had my CB400F2 serviced and now I've noticed one of the inside downtubes/Header pipes is showing signs of tarnishing a bit, the others not....your thoughts?
Pages: 1 ... 76 77 [78] 79
|
Show Posts