Honda-SOHC

Hi Myford,

I'll go along with the previous two posts - there are no seals or clamps where the pipes enter the collector box.
There is a seal and clamp at the other end of the collector, where the silencer fits.
I liaised with DSS when I bought my exhaust, to make sure I got all the right bits. I made a list of what I thought I needed,
the only thing I'd missed was the stand stop rubber (not in DSS parts list).
Slightly annoyingly I still had to buy bolts to fit the silencer to the new bracket I also bought, but you can't have everything!

Chris

Hi Drew,
The photo shows the part in situ on my bike - easy for me to look at as the tank is off at the moment.
There is also part 99 shown in the parts list called 'Band, Wire Harness' which looks like it should go between this part
and a corresponding hook on the frame. There isn't one on my bike.
I think the wire is the earth connector for the horn - on my bike it is fitted under the coil mount.
Chris

Hi all,
I came across this site and it looks good so I have signed up. I have just got a low mileage CB400/4 F2, some 37 years after I first fancied one - I never managed to get one in my younger days! I also currently have a CB250 G5 in bits (the same as one I did own back then). Now all I want are the bits I would have added to the bike had I got one back then, specifically a Rickman rack and crash bar, but there don't seem to be a lot about.
Looking forward to getting out and about on it when the weather warms up again.