11
CB350/400 / Re: Anyone recognise this bit?
« Last post by Laverda Dave on Today at 09:42:35 PM »It doesn't look long ke a carb part Roo, well not OEM anyway but does it have a thread on it? I'm just thinking maybe someone at some stage has taken the lifter spindle out and to do that you have to drill the locating dowl out. Of course it then has to be replaced! I've done this a couple of times in the past and used either a roll pin ground to length or in the case of Ratty I used a grub screw turned down on the lathe at the end to give a suitable locating 'register' into the spindle groove (as as previously suggested by Ken to someone else). Anyway, could it be that, is the spindle dowl missing?