Honda-SOHC

Hello Folks,

I would like install a new brake lines to my 400 Four. I want a Stainles Steel brake lines with a "classic" look(not colours). I will change the brake fluid, I will use "silicone" fluid, to avoid damage on the paint. Anybody knows where can I get it?? I am from Spain and Ebay is good for me or other dealer that send to Europe. Thank you in advance.

Hello all, I would like show my restauration Job of my  Honda Logo on my 400 four seat. Normally it is fade with the years or If you buy a new cover for your seat, you Will need paint a new  logo.

 You will need a Stencil Honda logo, a silver paint spray tin(this is a very economic paint, is better than you use a vinyl paint for this job) painter tape, trash bag or similar and a "precission" knife.

 The first is fit the Honda stencil over the old Honda logo, here there is a problem, the logo is not perfect because it has "curve shape" or irregular/distorsion form, the tail of the seat is curve and it is hard to fit the stencil over the logo, be patient, if you have a new seat cover without logo it is very easy .

 When you have the stencil fit, take out the stencil protection cover, it is transparent(look the pic).
 
Now cover the seat with trash bag  and painter tape or similar(look the pic).

Paint  time, move the tin over 1 minute and then sprayed a thin layer of paint, take a distance about 30cm, please follow the instructions tin, then let dry the paint 24h or more.

Now you can take out the bag trash and painter tape, the result is very good, you can use a precission knife to "cut" the rest of possible paint.

The only bad thing is that the Stencil does not fit perfect over the  Honda logo(the cover is  curve) but I think it is not very important, you can use a brush a  paint and give a "touch of paint" for a perfect look.

































To end, I use a small brush and re-touch the Honda Logo, I am very happy with the result.








I have more Stencils, If you need, contact me.

Sorry for my English!!!

Hi all, I would like to rebuild an old pair of KONI shock absorbers, no one knows what type and amount of oil should I use for them? I do not know the model, just know that has the red body and comes from an old 400 Four ....
Thank you in advance.

Hello all,

Can I use the seat from Hond CB500 Four in my CB550 K3?

Thank you.

My best tool!!tune-up my 400 and 550 Fours is very Easy with it!! Great accurate!!!

Hi all, anyone know what function have o'ring?
Number 283:
http://www.cmsnl.com/honda-cb400f-general-export-kph_model14637/partslist/E01-1.html#results

Best Regards.

Hello, I have one question about my camshaft, I take off the camshaft on my 400 four, it has stamped R6, I measure the camshaft  lobe measure and it is higher than HONDA specifications. Anybody knows that is the R6 code??
Thank you in advance and sorry for my English one more time...