This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bryanj
1
« on: November 28, 2023, 09:23:51 PM »
It does have standard threads, Whitworth, BSF and BSC
2
« on: November 27, 2023, 05:58:56 PM »
I will second that, i have a 500 head done by him
3
« on: November 26, 2023, 07:20:13 PM »
It would have been running, if at all increadibly rich
4
« on: November 26, 2023, 02:41:11 PM »
Ifvthe marks dont line up at tdc nothing you adjust will be right
5
« on: November 25, 2023, 01:08:14 PM »
Before you buy an aftermarket from us check with big all on here as he makes them and they fit, he may be slightly dearer but
1 it will fit, work and be correct
2 he will give fantastic after service
3 supports a forum member
6
« on: November 25, 2023, 12:23:33 PM »
Tank, have you got an old school radiator repair shop local, they may be able to solder patch(s) on.
Clutch the mechanism can be very finicky as is the adjustment, the was a bulletin on adjustement, shoul be in ashs dropbox, cable routing is vital, pdi and build list should also be in dropbox.
This sort of problem is one that is probably an easy fix in person but impossible at distance!
7
« on: November 23, 2023, 09:44:05 PM »
Have you read Ashs coil fix?
8
« on: November 22, 2023, 03:03:01 PM »
But thats not the msrket we are talking about
9
« on: November 22, 2023, 03:01:07 PM »
The cms link you posted says they are 750 by the part number, when fitted use a tape measure to measure the diameter of the shoes, there is also a max dia cast inside the drum.
Also has it been relined and machined too small?
10
« on: November 21, 2023, 10:56:01 PM »
Always knew you were a hooligan Julie
11
« on: November 21, 2023, 04:22:35 PM »
Amber is the requirement of law in several countries
12
« on: November 21, 2023, 04:20:17 PM »
You bought 750 ones which are bigger than 500/550 the middle part number should be 323 not 300
13
« on: November 20, 2023, 08:24:55 AM »
Dont know about brittle, but if the people who work on Argos all the time did it i would think it would be ok.
You have to be gentle with the heat and keep moving
14
« on: November 19, 2023, 08:03:19 PM »
Last weeks Bangers and Cash restoration team showed getting the shine back on an argo with a heat gun
15
« on: November 19, 2023, 07:59:05 PM »
As an experience of heart attack, a lot different i know, pester your consultant as to when you are fit then apply for it as paperwork will not be sent out until you have applied, they neglect to tell you that
|
Show Posts