Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mr Bond

Pages: [1]
1
Anorak's Corner / Re: 1977 carb outer diameter and spacing question.
« on: September 07, 2020, 08:28:40 PM »
Naturally, after posting this, found a thread on various carb spacing's in FAQ... BUT, none were ever measured for the 77 - 79 CB SOHC



2
Anorak's Corner / 1977 carb outer diameter and spacing question.
« on: September 07, 2020, 07:18:52 PM »
Apologies if asked before, but have looked in forum and cannot find an existing thread on this. Does anyone know the outer diameter of the carbs for a 1977 SOHC CB750, as well as the distance between centers of the bores for each carb? I am trying to make up a plenum for a custom build, but unfortunately the carbs are in the workshop 80 miles away and I can't get there to measure up for another 2 weeks. Want to be able to take a cardboard mock up with me then.

Thanks in advance.

3
CB750 / Re: Exhaust pipes DIY
« on: November 04, 2018, 07:33:49 PM »
How do. Nice to see the finished build. Did you build the exhausts yourself in the end? If so, do you remember the diameters inner and outer of the pipe you used? I am about to embark on building a stainless system for my K7 and need to buy the right size bends and pipe. Any help in that wpuld be greatly appreciated.

4
CB750 / Re: Exhaust pipes DIY
« on: November 03, 2018, 02:40:30 PM »
thanks, my idea was to make them myself.
Any help on size, materials and tips.

Regards
El__burro

How do mate, did you ever get those diameters in the end? Hope so, as I am trying to sort out the same info before attempting a stainless set of drag pipes for my chop. If you did, would you be willing to pass them on to me?

5
New Member Introductions / Re: Intro's
« on: April 19, 2018, 06:59:46 PM »
Cheers for that folks, will have a search for that now. Provided I can get this bloody white cat off my lap.

6
New Member Introductions / Intro's
« on: April 18, 2018, 07:24:43 AM »
How do folks.

Just joined on the recommendations of a friend who I believe has posted some pics of a wiring diagram/setup of how to wire up a CB900F Reg/Rectifier for a Cb750K bike... Hoping someone might have the link for this. AS for me, Am currently in possession of a K7 that was someones cafe racer project. I have taken it a bit further and have now got it mounted in an a 1984 Cyclehaven frame. Been stagnating in my garage for a year or so, but am finally starting to get a move on with the build. No doubt I will be back on here seeking words of wisdom re electrics, carb and engine mods.

Cheers.
Mr Bond
[ Guests cannot view attachments ]

Pages: [1]
SimplePortal 2.3.5 © 2008-2012, SimplePortal