This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bryanj
Pages: 1 2 [3] 4 5 ... 673
31
« on: April 25, 2024, 08:34:51 AM »
Trouble with the Haynes Ash it tries to cover the 350,400,500 and 550 the smaller ones are different enough to make that cnfusing rading.
I was told that Haynes had bought Clymer but not sure how true that is, their museum is worth a visit
32
« on: April 24, 2024, 05:04:28 PM »
Dave, i will email/pm you with the details of the oh shit factor
33
« on: April 24, 2024, 02:35:31 PM »
Bike or manual? The parts book on there is Japanese.
I supplied them all to Ash by the way.
I can still burn the all to a dvd for a small fee if wanted
34
« on: April 24, 2024, 02:33:59 PM »
If you have a V in your back yard i wanna see it.
If you have been to Kennedy you will know about the "Oh Shit" face when leaving the control room mockup and the last Apollo lying down at Houston is impressive
35
« on: April 24, 2024, 10:30:01 AM »
Alladins cave on here but you need the 500 manual plus the supplementsup to your model
36
« on: April 24, 2024, 10:28:55 AM »
The fact that the L was a half grade came from the same reptat suggested d7ev to me, and that man knew how to read plugs
37
« on: April 23, 2024, 06:50:28 PM »
Delta, i disagree,
On the asvise of an ngk rep who was a well respected sidcar racer i used D7EV in my 500 that went all over the UK and to the Isle of Man regularly plus commuting 7 miles to work.
Never fouled, never failed yes nearly twice the price but well worth it the =L was always sold as a "half grade"
38
« on: April 23, 2024, 03:27:33 PM »
Most cards for the trader the more you do the smaller the commission but the machines are damned expensive to buy
39
« on: April 23, 2024, 09:03:02 AM »
I think its 3/16 whitworth socket that will hammer onto that and undo it, never failed me when working for a Honda dealer, might be 1/4, its a long time since i did this
40
« on: April 21, 2024, 04:51:23 PM »
NOT MY FAULT! You asked for the jets mate!!!
41
« on: April 21, 2024, 04:27:01 PM »
If its realy that much of an angle use one from a bmw airhead where the master is under the tank and operated by cable from the lever
42
« on: April 20, 2024, 07:26:19 PM »
I seem to remember middle notch for needle which is 3rd from either end
43
« on: April 19, 2024, 08:06:56 PM »
Not those no sorry mate, whats left ofvthe carbs is after rebuilding a mate of mines at work and comfys on here and to be honest is a load of not much, the mains just went to Roo but i know at least 1 has a float so must have needle
44
« on: April 19, 2024, 04:20:46 PM »
Dave, i have a robbed set of 400 carbs, you can have what you want for postage
45
« on: April 18, 2024, 08:33:20 PM »
Looks purdy
Pages: 1 2 [3] 4 5 ... 673
|
Show Posts