This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - JohnS
Pages: [1]
1
« on: June 02, 2013, 09:48:41 PM »
Halfords 10W-40 is in the bike!
Thanks all,
John
2
« on: June 01, 2013, 10:16:26 PM »
Thanks Guys, I'll follow your advice.
3
« on: June 01, 2013, 03:31:58 PM »
As the day to start my rebuilt engine approaches my thoughts turn to oil!
The manual recommends SAE 10W - 40 SE for normal use.
I understand that this is an old oil designation and today's designations eg API, ACEA are not directly comparable.
I would welcome advice from those in the know.
Also should I use a special oil to run the engine in or just change it after ? 500 miles.
Many thanks.
4
« on: May 27, 2013, 10:21:48 PM »
Thanks for the offer meerkat, I've ordered some now.
If they are slow to arrive I get back to you.
John
5
« on: May 27, 2013, 10:17:52 PM »
Thanks Steve.
6
« on: May 27, 2013, 10:16:55 PM »
Thanks Piki, they look very interesting.
7
« on: May 26, 2013, 08:45:20 PM »
Thanks merkat, I'll try them.
John
8
« on: May 26, 2013, 11:59:35 AM »
Hi All,
Does anyone know if it is possible to replacement the HT leads from the coils to the spark plugs on a 400/4 or is it necessary to buy new coils?
Thanks,
John
9
« on: May 26, 2013, 10:28:33 AM »
Thanks Kent.
I've just looked at the site you suggested.
Unfortunately they stock only 3.9 mm and 4.7 mm bullets.
The original loom connectors and those on the replacement loom supplied by David Silver are 3.5 mm bullets.
American suppliers seem to stock them but not UK for some reason.
John
10
« on: May 26, 2013, 10:16:14 AM »
Thank you very much.
Excellent pictures!
John
11
« on: May 25, 2013, 07:27:42 PM »
Hi All,
Does anyone have a picture of the correct routing for the Carburetor breathing tubes for a 400 four?
Many thanks.
12
« on: May 25, 2013, 07:23:55 PM »
Hi All,
Does anyone have a UK supplier for the Honda standard 3.5 mm bullet connectors?
Many thanks.
13
« on: July 03, 2012, 10:40:39 PM »
Hello All!
Has anyone out there dismantled a 400/4 oil pump?
Could anyone tell me whether the spindle driving the oil pump should have an o-ring or a washer in the recess in the base of the pump?
Many thanks.
Pages: [1]
|
Show Posts