This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Ibby4585
1
« on: November 24, 2020, 07:35:27 PM »
Silvers have both 550f1 supersport do they run the same carbs?
2
« on: November 24, 2020, 07:30:33 PM »
Cheers Oddjob, that would make sense i may take a punt on some 550f ones then from Silvers.
3
« on: November 24, 2020, 07:04:27 PM »
Will have a hunt about.
Thats my exact problem, the inner cable length is too long.
Kris
4
« on: November 24, 2020, 06:46:51 PM »
The ones that I bought are from wemoto.
Would the cables from a cb500k0 73' fit they are in stock at Silvers?
Kris
5
« on: November 24, 2020, 04:56:06 PM »
Could anyone tell me a source to get correct cables for my project that don't cost the earth. Cmsnl want £33 for pull and £28 for a pull cable. Silvers only has a pull cable in stock and I've just bought a set on Ebay listed for a 550 and they are incorrect.
Any info would be great.
I'm in the UK.
Kris
6
« on: November 24, 2020, 04:52:14 PM »
Erny thats brilliant. Thank you so much.
Kris
7
« on: November 23, 2020, 01:39:33 PM »
Cool.
Thanks
Kris
8
« on: November 23, 2020, 10:16:53 AM »
OK cheers.
Will put them somewhere near that.
9
« on: November 23, 2020, 09:47:52 AM »
Ahh ok, do they go over the frame brace and down next to the battery and airbox?
10
« on: November 23, 2020, 09:09:50 AM »
I'm at the final bit of getting my cb550 started for the first time since 1984! The carbs will be going on next week but I'm short of the air vent pipes. I will make some up myself but can anyone tell me how long they should be and where they route please?
Cheers
Kris
11
« on: November 03, 2020, 07:07:34 PM »
Excellent. Cheers
12
« on: November 02, 2020, 05:19:14 PM »
Managed to sort it out this morning. The black red wire on my brand new OEM r/h switchgear needed to be wired into the brown white on the loom!! Looking at my old switchgear, it didn't have the black red only a brown white so I tried it and it all works.
Cheers
Kris
13
« on: November 02, 2020, 05:16:19 PM »
I'm looking for a set of 4 into 4 exhausts for my 75' 550. I've hunted around for a good secondhand set but they are rare. So I'm looking to buy replica set from Dave Silvers or Cmsnl. Silvers are showing out of stock but Cmsnl show in stock, are they the same builder/supplier? Does anyone have any feedback on quality? At £1000 a set they are not cheap so I expect them to be decent.
Any feedback would be great.
Kris
14
« on: November 02, 2020, 05:11:14 PM »
Hi Ibby4585
I can source 15A 8A & 5A Glass fuses (30mm L x 6.4mm Dia,) fairly cheaply but have yet to be able to find a source of 8A ones Try looking on the M&P motorcycle website will give you a idea of cost I have a trade account with them if that helps you
Nigel
Cheers Nigel. Will have a look around. Kris
15
« on: November 01, 2020, 10:47:23 PM »
Cheers Erny.
|
Show Posts