This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Johnny4428
Pages: 1 ... 134 135 [136] 137 138
2026
« on: June 09, 2020, 07:48:13 AM »
Thanks very much! found in Alladins Cave, just as I thought 1 1/2 turns. Yes they don’t make it easy I was beginning to think I had a set of 500 carbs, which I probably do but common to 550 also.
2027
« on: June 09, 2020, 07:32:55 AM »
Thanks, is that available online?
2028
« on: June 08, 2020, 10:41:41 PM »
Hi all, can anyone tell me what the base line setting is for the pilot system for my K3 as my Haynes doesn’t even cover these carbs. They are set 2 turns at the minute but I have a feeling they are supposed to be 1 1/2.
2029
« on: June 03, 2020, 09:29:58 AM »
I have experienced a bit of these woes, as many of the people on here have. I have had my carbs off three times and have found the easiest way for me is to remove air filter box and drop air box collector with intake rubbers attached loosen off 8 m6 nuts from intake manifold pull back and slide out. This is probably not much help but I have juggled between poor or faulty plugs “ngk” and blocked pilots and this was even after an initial complete strip and rebuild of carbs. I remember prior to a complete restoration of my bike I took the carbs off and they were ultrasonically cleaned, made no difference whatsoever probably pilots blocked. Also all four had blocked vents. I now have a bike that runs and ticks over very nicely, in fact I have never had the bike running like this in the 33 years I have owned it. You will get there, (hope it doesn’t take 33 years)! Good luck!.
2030
« on: June 02, 2020, 08:58:47 AM »
Small brass interference fit sleeve over it would sort it provided it didn’t interfere with float movement, if you knew somebody with a lathe. Otherwise replace carb body.
2031
« on: June 01, 2020, 09:19:31 AM »
Donation made, well worth it, where else will you find this level of sarcasm and help! 
2032
« on: May 31, 2020, 06:49:11 PM »
Hi Simon, that’s reassuring to know, when I purchased mine I think it was just at the start of re- production as I had waited a number of years to get a set. Thanks for reply!
2033
« on: May 31, 2020, 07:13:07 AM »
Has anyone on this forum had to use a series of ratchet straps and levers to fit a replacement set of exhausts which are supposedly been designed and manufactured to fit your particular model.  I suspect I’m not the only one, very annoying to fit to a newly painted frame without damaging or chipping. These pipes were purchased a few year ago I’m hoping that they are better now.
2034
« on: May 09, 2020, 10:44:49 AM »
Nice looking bike, if only we could take them out on the road. I’ve done a fair bit of fettling with mine, plugs out, plugs in, carbs off, cleaned pilots again carbs back on, electronic ignition off, points back on etc etc. I’ve now ended up with electronic ignition back on and pilot air screws 2 turns out and she is running and idling pretty good, but might be a spluttering heap once out on the road. I don5 like just running her in the garage as the engine has been fully rebuilt, need to get it working. I’m up in Orkney by the way.
2035
« on: March 03, 2020, 09:48:46 AM »
Thanks for your help guys, much appreciated.
2036
« on: March 03, 2020, 07:11:27 AM »
Hi all, anyone know what an appropriate colour would be for a 1977 CB550K3 handlebar control paint would be. I read somewhere that it’s more an orange rather than a red. I’m not sure so I appeal to the knowledge and power of the forum.
2037
« on: October 26, 2019, 10:35:09 AM »
Incidentally this is an NGK cap as are all caps on my K3. Don’t know whether these are original. New on order, Dave Silvers. No other known fixings on these.
2038
« on: October 26, 2019, 09:07:37 AM »
This I discovered last night checking the electrics, timing etc. Trimming the HT leads and reconnecting, this screwed off with the cable, not much holding it!
2039
« on: October 26, 2019, 08:57:44 AM »
Absolutely brilliant, love this bit of craftsmanship. Good job!
2040
« on: October 18, 2019, 08:38:57 AM »
Very nice bike! Great restoration and lovely colour.
Pages: 1 ... 134 135 [136] 137 138
|
Show Posts