This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Topics - captaink
46
« on: August 18, 2015, 10:36:26 PM »
Hi, simple question
what's the best jointing sealer for the engine cases ?
Regards Keith
47
« on: August 18, 2015, 08:05:36 PM »
I put this question on the project section but it might be better here
These two holes in the lower case of the cb750 F2 engine
What are they for ?
They appear to be dead holes going nowhere
Lastly what does this steel shaft and pin do and are they removable ?
48
« on: August 05, 2015, 06:01:51 PM »
Well here it is by popular demand,,,,well one person.
The build thread for the CR 750 replica build.
The frame is 1977 and I have cut a few of the brackets off and semi tidied them up.
The frame lock is ground out and welded over
As a guide I have ordered a seat for alignment of the centre bracket with the cut out for the oil tank cap that's to be welded back in.
But of course I have a CR replica already as a pattern for making all my own brackets.
I have ordered an ally fuel and oil tank but delivery is 9 months although I can cancel this at no cost if one becomes available sooner.
A few pics of my Cr in Honda colours
49
« on: August 02, 2015, 01:47:10 PM »
Posts moved from newbie.
Gearbox now opened up and inspected all looks good
50
« on: July 23, 2015, 08:15:22 PM »
Hi all, where's the best place to obtain geniune engine parts for the f2 engine
Regards keith
51
« on: July 23, 2015, 06:40:52 PM »
Hi, are all the engine breather covers on the rocker boxes the same ?
I have one with a broken off fixing lug and need to replace it or repair it,
Easier to replace and cheap but not sure if all the same
Regards keith
52
« on: July 16, 2015, 10:11:35 PM »
Hi, I'm considering either rebuilding my cb750 f2 engine or getting a reliable Honda engine builder to do it.
Is there anyone in the Kent area or within 100 miles or so ?
Cheers
Keith
53
« on: July 15, 2015, 08:15:54 AM »
Is there any companies that specialise in the rebuilding / checking/ setting up of the set of cb750 carbs.
I was considering doing it myself but it may be better to have them done
Regards keith
54
« on: July 14, 2015, 10:21:23 PM »
Hi, I have a rear light stamped Honda Stanley which is approx 7 inches wide
What I'm looking for is a Honda rear light that's aprox 5 inches wide.
It's going on the Honda rickman cb750 but with the single seat and rear section behind it looks too big and overhangs , there's a smaller width one .
Does anyone know what model it's off
Regards Keith
55
« on: July 12, 2015, 06:21:39 PM »
As some may know i buggered up the plastic headlight shell on my Rickman 750 project.
I don't often screw things up but there you go.
Anyway.
On my 1979/80 rickman what would be the correct model of shell would rickman have used a 1979 model she'll ?
Any help appreciated, if you have one for sale even better
Regards keith
56
« on: July 03, 2015, 08:24:21 PM »
Joined the sohc forum and redirected here as well, so here I am.
|
Show Posts