This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bryanj
16
« on: May 18, 2024, 08:18:14 PM »
Have you considered that running 17/35 sprockets has dropped your revs for running speed and may be contributing to your running problem? It was designed to cruise at a certain rev range
17
« on: May 18, 2024, 04:26:03 PM »
Do you not have an old sprocket to give him?
18
« on: May 18, 2024, 09:17:10 AM »
I did some math and 17/39 is damn near same as 15/35 and the cms one would be here fairly quicly. The rear sprocket part numbers only fit the various 450 models according to cms so probably not easy to get aftermarket now
19
« on: May 18, 2024, 08:17:22 AM »
15 to 17 is a big jump, personally i would fit one of the bigger rears from cms to compensate
20
« on: May 18, 2024, 08:14:45 AM »
De gunge the bad bits and paintwith smoothright or similar but you willhave to opeup lower yoke a bit so as not to scape paint off, the rest of the i thin will run ok but cant get close enough on pics. I replied to your pm with a fix for the seal ares if needed
21
« on: May 17, 2024, 08:02:58 PM »
Tie the lever to the bars and walk away for 24 hours and/or threaten to throw the f*▪︎kn thing out the window. Worked for me at Meads
22
« on: May 17, 2024, 08:01:53 PM »
Seals will never get that far up the tubes, i can give you a "dirty" fix that will last a while if you pm me
23
« on: May 17, 2024, 05:57:57 PM »
CMS show 38 and 39 toothin stock, what size are you after
24
« on: May 17, 2024, 05:35:02 PM »
That would mean you could regrind a crank, does anybody know if the journals are hardened cos i dont
25
« on: May 17, 2024, 12:38:01 PM »
Years ago i went to UK2.NET and now pay about £6 a year for blj.org.uk and they happily forward emails sent to there to as many other addresses as i wish, this is why if you hit reply on one of my mails it disapears and i dont recieve it but that dont bother me as if people dont read the bit where i say only send to blj@blj.org.uk do i need to talk to them!
26
« on: May 17, 2024, 08:24:40 AM »
Thank you very much for all your kind comments, just talking/reading/answering brings a modicum of reality back
27
« on: May 17, 2024, 08:22:50 AM »
The hill yes, roads at the top close differently but usually the cirencester one, watch out for the new roundabout just after the one at top of hill
28
« on: May 16, 2024, 08:15:29 PM »
You should find the spring washer will fit over the plain shank of the bolt but the plain washer will not
29
« on: May 16, 2024, 08:13:30 PM »
John, DO NOT pretend to be a coach in Bourton, they are now banned and not allowed to park!!!
30
« on: May 16, 2024, 08:12:09 PM »
On an old bike it was always stated at estimate time that any extra work due to broken/siezed bolts was at the expense of the owner
|