Recent Posts

Pages: 1 [2] 3 4 ... 10
11
The Black Bomber Board / Re: 67` Bomber running problems
« Last post by Bryanj on Today at 08:17:22 AM »
15 to 17 is a big jump, personally i would fit one of the bigger rears from cms to compensate
12
Project Board / Re: Mike's CB550 Project
« Last post by Bryanj on Today at 08:14:45 AM »
De gunge the bad bits and paintwith smoothright or similar but you willhave to opeup lower yoke a bit so as not to scape paint off, the rest of the i thin will run ok but cant get close enough on pics. I replied to your pm with a fix for the seal ares if needed
13
CB500/550 / Re: NGK plugs for 500
« Last post by Toko_Jo on May 17, 2024, 10:57:27 PM »
Quote from: deltarider on May 17, 2024, 03:47:41 PM

It's a year old debate. I don't see any advantage whatsoever adding resistance over what NGK recommends.

For a change I actually agree with you DR   :D
14
Project Board / Re: Mike's CB550 Project
« Last post by DomP on May 17, 2024, 09:51:31 PM »
That's exactly like mine Mike, pitted below the lower triple by around an inch or so, I think Julie has a good plan there, use it now but send them off during those miserable winter months
15
Project Board / Re: Mike's CB550 Project
« Last post by Mike_Berkshire on May 17, 2024, 09:37:12 PM »
This is the pitting:
16
Project Board / Re: Mike's CB550 Project
« Last post by Mike_Berkshire on May 17, 2024, 09:32:15 PM »
Thanks Julie and Bryan. Bryan I will PM you.
17
Project Board / Re: Doms CB550F1 project
« Last post by DomP on May 17, 2024, 09:08:29 PM »
Quote from: Laverdaroo on May 17, 2024, 09:02:52 PM
I might have stuffed you there Dom, I’ve checked my other ones and I put the kit into the one on the bike that’s on now‍

My heads a shed it appears, I might have a spare kit and off out to the Shed of Dreams in a bit, I’ll have a rummage

My bad!


Sent from my iPhone using Tapatalk

It's moving fluid Roo, whether it's under enough pressure though I'm not sure
18
Project Board / Re: Doms CB550F1 project
« Last post by Laverdaroo on May 17, 2024, 09:02:52 PM »
I might have stuffed you there Dom, I’ve checked my other ones and I put the kit into the one on the bike that’s on now‍

My heads a shed it appears, I might have a spare kit and off out to the Shed of Dreams in a bit, I’ll have a rummage

My bad!


Sent from my iPhone using Tapatalk
19
Project Board / Re: Doms CB550F1 project
« Last post by DomP on May 17, 2024, 08:47:33 PM »
I've got two other lines of investigation,  first is that I've used a banjo bolt on the caliper but I believe it is short enough that it doesn't bottom out on the caliper. Second is that the mc needs new seals but Roo thought it was rebuilt so I'm kinda assuming that much.
20
Project Board / Re: Doms CB550F1 project
« Last post by DomP on May 17, 2024, 08:31:36 PM »
Tried that Bryan😪
Pages: 1 [2] 3 4 ... 10
SimplePortal 2.3.5 © 2008-2012, SimplePortal