Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Phil A

Pages: [1]
1
CB750 / K7 exhaust gaskets.
« on: October 29, 2018, 10:00:13 AM »
I think I know the answer to this, but just in case I’m going to ask anyway.
I took the exhaust off, one side, so I could refit the centre stand. I thought it might be difficult to remove but the nuts came undone very easily. There is no copper gasket/ oring fitted. The exhaust fitted is an aftermarket 2 - 1. I’m not sure of the make.
So my question is should I fit copper gaskets when I refit the exhaust?


2
New Member Introductions / New member
« on: August 20, 2018, 02:19:03 PM »
Hi everyone,
I bought a Honda CB750 K7 in April, that had been imported from the USA, to ride during the summer. It wasn’t quite as good as I was led to believe so have only just about got it ready to go now.


Pages: [1]
SimplePortal 2.3.5 © 2008-2012, SimplePortal