Honda-SOHC
SOHC.co.uk Forums => CB350/400 => Topic started by: McCabe-Thiele (Ted) on November 18, 2020, 03:55:58 PM
-
My manual states a suitable 10 mm should be used to withdraw the rocker shafts.
Firstly are all 10mm bolts the same thread or is there a fine & coarse option? I have as yet to buy a selection of useful metric bolts so any suggestion as to suitable length is welcome.
-
There are 3 different pitches on 10 mmbut that sounds a bit bit are you sure its not 6mm (10mm spanner)
-
I'm going off the Haynes Manual kit shows the 550 as 6mm.
-
if its a 400/4 any m10 bolt out the engine will fit i use them every time
[/quote
OK but as I don't understand metric is that a fine thread?
-
I've removed the first on by putting a close sized bolt in the hole and pushing it to one side so the threads touch - it pulled out with no effort!
-
Bolt size is M10x1.25
Kevin