This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - steven400/4
1
« on: November 19, 2020, 08:03:00 PM »
thanks mate
2
« on: November 19, 2020, 04:39:42 PM »
can someone remind me how you work out what bearing it is you need is it the number on the side of the con rod and the letter on the crank
thanks
3
« on: November 18, 2020, 08:00:16 PM »
4
« on: November 18, 2020, 07:54:48 PM »
no need for wood block engine is wider than the frame so it will rest on the frame
5
« on: November 16, 2020, 03:08:47 PM »
i,ve sent terry a message but no reply as yet
6
« on: November 15, 2020, 10:34:38 AM »
7
« on: November 15, 2020, 08:40:52 AM »
thanks k2 k6 i ordered a tap yesturday before i saw your reply lol i have sent that terry a message asking what he thinks what i can do
8
« on: November 14, 2020, 07:18:33 PM »
all i,ve dune is change the head gasket as it was leaking
9
« on: November 14, 2020, 06:41:39 PM »
not been on the floor and yes thread gone on bolt and case not a happy chap i spent 8k building this bike with all new genuine parts that took 10 years to find now i,m trying to find some engine cases with the same letters on the bottom case so i dont have to work out and find some new shells again
10
« on: November 14, 2020, 01:49:58 PM »
ok peeps i just rebuilt my top end i had an oil leek from some where so i just started it up it ran soon as fuel got into the carbs i rev it and there was 1 small pop from the engine then i noticed oil all over the floor i noticed the oil filter was loose but i never touched it on the rebuild at all the thread on the bolt is stripped so could the pop i heard been the bolt popping out is if could there be anything i,ve done on the rebuild to corse it to happen
11
« on: October 11, 2020, 09:19:01 PM »
10 washers are part number 90441422000 the other 2 part number is 90442377000 thoise two have a seal in the middle i am looking at a full set of new washers for my engine rebuild
12
« on: May 11, 2017, 07:16:03 PM »
spray the numbers with carb cleaner it will stand out till the cleaner runs off it always works for me
13
« on: March 07, 2017, 06:50:34 PM »
you can still get did rims and genuine spokes of german ebay
14
« on: January 28, 2017, 08:03:00 PM »
15
« on: February 28, 2016, 07:20:02 PM »
and how do i get onto that 
|
Show Posts
