This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - steven400/4
Pages: 1 2 [3] 4 5 ... 21
31
« on: February 19, 2015, 06:14:36 PM »
mine are black on all my 400/4 i was told suzuki gt 750 are the same type but they only have three so u,d need to order an extra one but i could,nt say if they were black or not
32
« on: January 12, 2015, 08:34:06 PM »
if they as the model of the cbr600 it was a fn model
33
« on: January 12, 2015, 08:31:14 PM »
cbr 600 1993 are the same if dss have any in
34
« on: January 06, 2015, 08:47:42 PM »
two rubbers should have one and 3 on and two should have 2 and 4 on the number goes at the top 1 at the top on n/s of engine 2 next to it and so on so on
35
« on: January 02, 2015, 09:20:25 PM »
ok i can look in my stash to see if i have an old one if you get stuck but not sure i there is any in the boxes
36
« on: January 02, 2015, 08:58:41 PM »
i thought the one at the bottom of the airfilter box was the only one that had the pinch slit at the bottom the one on the air chamber was just a hole ??
37
« on: December 29, 2014, 05:16:43 PM »
if it looks like a rubber washer its a dust seal for the bearing
can get stand pins from david silver spears i heated mine up and hammer,d it out
38
« on: December 17, 2014, 06:29:39 PM »
i,ve tryed todo about 5 gear levers they all broke so i have them chromed complete know just unscrew the adjuster rod to put new boots on
39
« on: November 06, 2014, 02:12:39 PM »
thanks ash thats great my i,m doing a cafe racer for a laff its a chituma125 it has honda clocks on it no rev counter but there is a hole on the engine at the front near where the clutch cable goes it look the same as the rev cable on my 400/4 so we are trying to find out if it had a rev counter on the bike b4 they change,d to the honda clocks
40
« on: November 06, 2014, 09:57:23 AM »
i,ve tryed that ash but my pc wont let me download it thats why i,m looking for someone that mite have one so they can send it to me
steve
41
« on: November 06, 2014, 09:28:33 AM »
does anyone have a pdf file of a chituma 125 manual 
42
« on: October 25, 2014, 07:01:44 PM »
thanks gents i,m building a cafe racer for my lad most of the speedos i have looked at say 2.1 ratio but the taco,s say 1.4 or 1.7 i no taco dont matter that much but would be good to get the speedo right 
43
« on: October 24, 2014, 11:01:19 PM »
44
« on: October 23, 2014, 09:25:46 AM »
or use the speed of an air gun that worked on mine
45
« on: October 17, 2014, 07:50:26 PM »
is the bottom hole a oil drain and the top a oil feed  ??
Pages: 1 2 [3] 4 5 ... 21
|
Show Posts
